Rational iCombi Pro Original Installation Instructions page 33

Secure the device using the fixing set.
n
Non-mobile stand
Align stand horizontally
a
The device is installed on the stand and is on the intended installation sur-
face.
1. Place two spirit levels on the device: One spirit level along the right edge of
the device and one spirit level along the front edge.
2. To align the device horizontally on the right, turn the stand feet on the front
right and rear right.
3. To align the device horizontally on the left, turn the stand feet on the front
left and rear left.
Fix the stand
Secure the stand against slipping using the fixing set.
The fixing set, including special adhesive, screws and dowels, is not included in
the scope of supply for the devices and can be ordered separately from the
manufacturer under item number 8700.0317.
Observe the distances between the foot locks for the respective device sizes:
x [mm]
x [inch]
a
The foot locks and the fixing set are available.
1. Secure the foot locks for the front feet to the floor with the special adhesive
or screws and dowels. Make sure that both foot locks point forward with
the openings.
80.06.083_iCombiPro-iCombiClassic_IM_en-US
6 half size - 10 half size
755.5
29 3/4
6 full size - 10 full size
977.5
38 1/2
5 | Setup
33 / 96