Multitech MultiVOIP MVP210 User Manual page 105

Field Name
Channel
Call Details
Duration
Mode
Voice Coder
IP Call Type
IP Call Direction
Packet Details
Packets Sent
Packets Rcvd
Bytes Sent
Bytes Rcvd
Packets Lost
From – To Details
Gateway Name
(from)
IP Address (from)
Options
Gateway Name (to)
IP Address (to)
Options
DTMF/Other Details
Prefix Matched
Outbound Digits Sent
Outbound Digits
Received
Server Details
DTMF Capability
Table is continued on next page...
Multi-Tech Systems, Inc.
Call Progress Details: Field Definitions
Values Description
1-n Number of data channel or time slot on which the call is carried. This is the
channel for which call-progress details are being viewed.
H/M/S The length of the call in hours, minutes, and seconds (hh:mm:ss).
Voice or FAX Indicates whether the call being described was a voice call or a FAX call.
G.723, G.729, The voice coder being used on this call.
G.711, etc.
H.323, SIP, or Indicates the Call Signaling protocol used for the call (H.323, SIP, or SPP).
SPP The –SS and –FX series only support SIP.
incoming, Indicates whether the call in question is an incoming call or an outgoing
outgoing call.
integer value The number of data packets sent over the IP network in the course of this
call.
integer value The number of data packets received over the IP network in the course of
this call.
integer value The number of bytes of data sent over the IP network in the course of this
call.
integer value The number of bytes of data received over the IP network in the course of
this call.
integer value The number of voice packets from this call that were lost after being
received from the IP network.
alphanumeric Identifier for the VOIP gateway that handled the origination of this call.
string
IP address from which the call was received.
n.n.n.n
SC, FEC Displays VOIP transmission options in use on the current call. These may
include Forward Error Correction or Silence Compression.
alphanumeric Identifier for the VOIP gateway that handled the completion of this call.
string
IP address to which the call was sent.
n.n.n.n
SC, FEC Displays VOIP transmission options in use on the current call. These may
include Forward Error Correction or Silence Compression.
specified Displays the dialed digits that were matched to a phonebook entry.
dialing digits
0-9, #, * The digits transmitted by the MultiVOIP to the PBX/telco for this call.
0-9, #, * Of the digits transmitted by the MultiVOIP to the PBX/telco for this call,
these are the digits that were confirmed as being received.
The IP address (etc.) of the traffic control server (if any) being used
n.n.n.n
and/or other (whether an H.323 gatekeeper, a SIP proxy, or an SPP registrar gateway)
related will be displayed here if the call is handled through that server.
descriptions
inband, Indicates whether the DTMF dialing digits are carried "Inband" or "Out of
out of band Band." The corresponding field values differ for the 3 different VOIP
Expressions protocols.
differ slightly For H.323, this field can display "Out of Band" or "Inband". For SIP it can
for different display either "Out of Band RFC2833" or "Out of Band SIP INFO" to
Call Signaling indicate the out-of-band condition or "Inband" to indicate the in-band
protocols condition. For SPP it can display "Out of Band RFC2833" or "Inband".
(H.323, SIP, or
SPP).
Chapter 6: Using the Software
Description
105