Fena-01/-11/-21 Configuration Parameters - Group C; (Group 3) - ABB FENA-01 User Manual

FENA-01/-11/-21 configuration parameters – group C (group 3)
Note: The actual parameter group number depends on the drive
type. Group C (group 3) corresponds to:
•
parameter group 54 in ACS355
•
parameter group 52 in ACSM1, ACS480, ACS580, ACS850
and ACQ810
•
parameter group is typically 52/55 (group 152/155 in some
variants) in ACS880 and ACS880-M04 if the adapter is
installed as fieldbus adapter A/B.
1)
No. Name/Value
01 FBA A/B data in1
(drive to client)
0 = None
101...9999
02... Data in 2 ...
12 Data in 12
1)
The number of parameters in this group may vary by drive type and drive firmware.
Description
Selects the drive parameter address from
which the data is read to the Data in 1 register
(from the server to the client). The Modbus
register address maps are explained in
chapter Modbus/TCP – Communication
protocol.
The content is defined by a decimal number in
the range of 0 to 9999 as follows:
0 Not used
1...99 Virtual address area of drive
control. Not used when the
Modbus/TCP protocol is used.
101... Parameter area of the drive
9999
Not used
Parameter index with format xxyy, where
• xx is the parameter group number (1...99)
• yy is the parameter number index within
that group (01...99).
Note: In ACS480, ACS580 and ACS880,
choose Other to display a list of mappable
drive parameters.
See parameter 01 FBA A/B data
Modbus/TCP – Start-up
in1.
65
Default
0 = None
0 = None