Installing The Adapter Module - ABB FENA-01 User Manual

44 Mechanical installation

Installing the adapter module

WARNING! Obey the safety instructions. See chapter
Safety instructions
instructions, injury or death can occur.
The adapter module has a specific position in the drive. Plastic
pins, a lock and one screw to hold the adapter module in place.
The screw also makes an electrical connection between the
module and drive frame for cable shield termination.
When the adapter module is installed, it makes the signal and
power connection to the drive through a 20-pin connector.
When you install or remove the adapter module from the control
unit:
1. Pull out the lock.
on page 19. If you ignore the safety
1