Tools - ABB FENA-01 User Manual

1)
In addition to Modbus/TCP, FENA-01/-11/-21 supports Modbus over
UDP.
2)
In addition to these protocol, it is possible to have the no communication
protocol running on FENA adapter module. This configuration is called
NONE protocol. In this setup, FENA adapter module is used only for
running Ethernet services which can be enabled/disabled via Web
pages. See Appendix C – FENA configuration web pages
Also SNTP is available with NONE protocol).
The below table specifies the clients/masters that are compatible
with the supported protocols.
Protocol
1)
Modbus/TCP
EtherNet/IP
PROFINET IO


Tools

The FENA-11/-21 adapter module can be used in the Ethernet tool
network for ACS880. The Ethernet tool network enables
commissioning and monitoring several single drives, or inverter
and supply units of a multi-drive from a single location by using the
Drive composer pro PC tool.
Note: When the FENA-11/-21 adapter module is used only in the
Ethernet tool network, the recommended setting for parameters
Compatible client/master
All Modbus/TCP clients that support:
• Modbus Application Protocol Specification v1.1b
• Modbus Messaging on TCP/IP Implementation Guide
v1.0b
All EtherNet/IP clients that support:
• The CIP Networks Library, Volume 1, Common
Industrial Protocol (CIP), Edition 3.0 May, 2006
• The CIP Networks Library, Volume 2, EtherNet/IP
Adaptation of CIP, Edition 1.2 May, 2006
• Recommended Functionality for EtherNet/IP Devices
Version 1.2, Feb., 2006
All PROFINET IO masters that support:
• GSDML file version 2.31
• PROFINET IO protocol according IEC standards
61158 and 61784
• PROFINET-IO conformance class B
Introduction to the manual 25
on page 435.