Fepl-02 Configuration Parameters - Group A (Group 1) - ABB FEPL-02 Ethernet POWERLINK User Manual

FEPL-02 configuration parameters – group A (group 1)
Note: The actual parameter group number depends on the drive
type. Group A (group 1) corresponds to:
•
parameter group 51 in ACS355, ACS380, ACSM1, ACS580,
ACS850 and ACQ810
•
parameter group 51 in ACS880 if the adapter is installed as
fieldbus adapter A or group 54 if the adapter is installed as
fieldbus adapter B.
No. Name/Value
01 FBA type
02 Profile
0 = CiA 402
1 = ABB Drives
profile
2 = Transparent16
3 = Transparent32
03 Node ID
0...239
Description
Read-only. Shows the fieldbus adapter
type as detected by the drive. The value
cannot be adjusted by the user.
If the value is 0 = None, the communication
between the drive and the module has not
been established.
Selects the communication profile for the
network connection.
CANopen device profile CiA 402
ABB Drives profile
Transparent 16 profile
Transparent 32 profile
Defines the node number of the device.
Two units with the same address are not
allowed on-line.
Node number
Start-up 33
Default
136 =
ETH Pwrlink
0 = CiA 402
1