Auerswald COMpact 5010 VoIP Configuration Manual page 15

Creating Internal Groups
Create the internal groups required.
To do this, open the page displayed in the fig-
ure to the right.
In the "Telephone Number" column under
"from:", enter a telephone number for the
group.
Under "Name" enter a suitable name with a
maximum of 16 characters.
Then click the "Execute" button to apply the
settings to the PBX.
Configure the settings for all additional groups
required.
If you have contiguous telephone number ranges, you can
enter the beginning and end values under "from: until".
Note
Only after clicking "Execute" will the name be available for
entries.
Assigning Subscribers to a Group (with Ringer Delay)
Assign subscribers to the available groups.
To do this, open the page displayed in the fig-
ure to the right.
Under "Please select a group:", select the
group to be configured first from the list field.
In the column "Telephone number / name"
under "from: until:", select all the subscribers
from the list fields that should be called when
the group is called.
Then click the "Execute" button to apply the
settings to the PBX.
If some of the subscribers should get a
delayed call when the group is called, activate
this under "Ringing delay (is only valid for
ringing sequence "all")".
Then click the "Execute" button to apply the
settings to the PBX.
Configure the settings for all additional
groups.
This completes group creation.
The ringer delay time set to 5 seconds can be changed on
page COMset Internal numbers
Note
Configure Reachability. You also have the option of
selecting other ringing sequences (for more on this, refer
to Ringing Sequence on page
When a group is created, the existing settings under "Status of
inbound/outbound calls" do not need to be changed for the call dis-
tribution to be correct (see also
The figure shows you the following page with the settings for
COMset
The figure shows you the following page with the settings for
COMset
Groups Properties
60).
Assign, Log in, Log out on page 59
Example 1: Basic Configuration with Internal Subscribers and Call Distribution
Internal numbers Groups
During the configuration process using the configuration assistant, a
group is automatically created for each external telephone number.
You can delete groups, which are no longer needed, on this page.
Under "Action", configure Delete and select the groups to be deleted
from the left column. Then click the "Execute" button.
Internal numbers Groups
During configuration using the configuration assistant, groups are
automatically created and – depending on the call distribution – sub-
scribers are assigned to these groups. On this page, you can delete
subscribers that should no longer be called when the group is called.
Under "Action", configure Delete and select the subscribers to be
deleted from the group in the left column. Then click the "Execute"
button.
).
Configuration Manual
Example 1 on page
Telephone numbers
Example 1 on page
Subscriber assignment
11:
11:
15