Auerswald COMpact 5010 VoIP Configuration Manual page 14

Configuration Manual
Example 1: Basic Configuration with Internal Subscribers and Call Distribution
ISDN Subscribers
Assign the internal telephone numbers from
your telephone number plan to the internal S
and U ports.
P0
To do this, open the page displayed in the fig-
ure to the right.
In the "Telephone Number" column under
"from:", enter a telephone number from your
telephone number plan.
Under "Name", enter a suitable name with a
maximum of 16 characters.
Under "Port", select the S /U
0 P0
end device is connected to from the list field.
Under "Device type", select a suitable type
for your end device from the list field.
Then click the "Execute" button to apply the settings to the PBX.
Configure the settings for all additional telephone numbers.
This completes the configuration of the ISDN subscribers.
If you have contiguous telephone number ranges, you can
enter the beginning and end values under "from: until".
Note
Only after clicking "Execute" will the name, port and
device type be available for entries.
It is a good idea to not connect more than two devices on
each S port in order to allow separate calling on either of the two B
0
channels.
The internal telephone number entered here needs to be entered in
the ISDN unit or system telephone as the (first) MSN. Also for an
Analog Subscribers
Assign internal telephone numbers from your
telephone number plan to the internal a/b
ports.
To do this, open the page displayed in the fig-
ure to the right.
In the "Telephone Number" column under
"from:", enter a telephone number from your
telephone number plan.
Under "Name", enter a suitable name with a
maximum of 16 characters.
Under "Port", select the a/b port that the end
device is connected to from the list field.
Under "Device type", select a suitable type
for your end device from the list field.
Then click the "Execute" button to apply the
settings to the PBX.
Configure the settings for all additional tele-
phone numbers.
This completes the configuration of the ana-
log subscribers.
If you have contiguous telephone number ranges, you can
enter the beginning and end values under "from: until".
Note
Only after clicking "Execute" will the name, port and
device type be available for entries.
As opposed to an S
nected to an a/b port.
Internal subscribers were already created during the con-
figuration with the configuration assistant. You can delete
analog subscribers, which are no longer needed, on this
page. Under "Action", configure Delete and select the
subscribers to be deleted from the left column. Then click
the "Execute" button.
14
The figure shows you the following page with the settings for
0
COMset
ports that the
The figure shows you the following page with the settings for
COMset
port, only one telephone can be con-
0
Internal numbers Subscriber (scr)
ISDN unit, make sure that the telephone number is transmitted to the
PBX.
One system telephone, COMfortel 1500/2500, can be connected to
each U port. When using standard ISDN telephones, a U
P0
adapter is required. For more information on this, refer to the descrip-
tion in the Installation Manual (chapter Connection of ISDN and Sys-
tem Telephones to the U
Internal subscribers were already created during the configuration
with the configuration assistant. You can delete ISDN subscribers,
which are no longer needed, on this page. Under "Action", configure
Delete and select the subscribers to be deleted from the left column.
Then click the "Execute" button.
Internal numbers Subscriber (scr)
Example 1 on page
Telephone numbers ISDN subscribers
port).
P0
Example 1 on page
Telephone numbers Analog subscribers
11:
/S
P0 0
11: