Procedure D1: Powder Tube And Penetrant Testing Version Powder Tube - Sames inocoat Inogun A Instruction Manual

6.4.4. Procedure D1: Powder tube and penetrant testing version powder tube

• Start unscrewing the powder tube with a 14 mm pipe
wrench, then continue manually.
• Extract the powder tube from the projector.
• Clean the inside of the powder tube with compressed
air, possibly the outside.
• Check the condition of the O-rings (A) and powder
tube, replace if necessary.
• Before reassembling the powder tube, blow its housing in the direction of rear body towards the outside of the
projector.
• Insert the tube into the projector, it automatically positions itself and pushes it to the stop.
• Tighten manually and then continue tightening with the 14 mm pipe wrench.
A
37
DRT7133
D - 2023/01
Member of Exel group