Maintenance; Summary Table Of Maintenance Operations - Sames inocoat Inogun A Instruction Manual

6. Maintenance

Preventive maintenance is an essential part of production and ensures the reliability of the installation. As a reminder,
the performance of equipment can only be guaranteed if a minimum of control and cleaning operations are performed
on this equipment.
Soiling and wear of the Inogun A projectors caused by the passage of powder depend on the
operating and application conditions and the production rates
Switch off the power supply to the control module before connecting the spray gun. Before
disconnecting the spray gun, switch off, disconnect the power supply to the Inocontroller or
Inobox (otherwise, a malfunction may occur).

6.1. Summary table of maintenance operations

The maintenance intervals indicated in the procedures below are only indicative. The user will have to create his own
maintenance schedule as he use Sames equipment.
Procedure
A1 Cleaning of projector exterior
A
A2 Cleaning of electrode support and deflector
Holding flange maintenance
B B1 Replacement of air nipple
B2 Replacement of o-ring
Rear body maintenance
C
C1 Replacement
Gun assembly maintenance
D1 Powder tube and penetrant testing version powder tube
D
D2 Protective cover assembly
D3 Replacement of HVU
Maintenance of 60° and 90° nozzle adapters
E
E1 Replacement of o-rings and 60° and 90° elbows
Detail
Cleaning
Replacement
32
DRT7133
D - 2023/01
Duration Frequency
2 min 8 hours
2 min 8 hours
2 min -
2 min -
5 min -
2 min -
2 min -
5 min -
5 min -
Member of Exel group