Introduction - Sames inocoat Inogun A Instruction Manual

2. Introduction

The Inogun A projector is an automatic projector designed to project powder paint. An
ionizing electrode at the end of the projector is set to a high negative electrical potential. Due to the high electric field
at the end of this electrode, it creates negative gas ions. These ions allow the powder paint to be sprayed during its
transfer from the end of the projector to the part to be painted, which is itself connected to the ground.
The Inogun A projector is connected to an Inocontroller or Inobox control module that controls both the high
voltage and the powder output of the projector connected to it. These two indissociable elements constitute a
powder coating equipment.
Pre-programmed voltage and current settings can be adjusted from the Inocontroller or Inobox control module.
Inogun A projectors are of two types:
• The FCC Inogun A projector is used in a powder coating booth with quick colour change.
• The Inogun A projector in the standard version is used in all other cases. It can be installed either on a
reciprocator robot via its support arm or on a 6-axis robot via a robotic support.
There are 3 versions of robotic support:
• 60° support for a projector.
• Twin convergent 60° support for two projectors
• 60° Twin parallel 60° support for two projectors.
Inogun A FCC
Inogun A
16
DRT7133
D - 2023/01
Member of Exel group