Table of Contents
Advertisement
6.4.6. Procedure D1: Powder duct
• Step 1: Extract the powder duct from the handle.
• Step 2: Reassembly
1 Clean the inside of the powder duct with
compressed air.
2 Check the condition of the seal and the powder
duct, change them if necessary.
3 Insert the duct from the top of the handle, taking
care to place the wires on the side opposite the air
duct (the wires must not touch the sharp angle of
the handle).
33
DRT7132
D - 2022 /09
Member of Exel group
Advertisement
Table of Contents
