Table of Contents
Advertisement
• Push the seal back into the groove of the connector to
hold it in position.
• Screw the rear support onto the support tube using a
13 mm open-end wrench.
• Connect the air and powder hoses to the projector.
5.2.3. Installation of the counter electrode for the standard Inogun A version
• Remove the holding flange
• Separate the rear body from the projector to release
the cap.
• Install the counter electrode connection instead. Push
back the rear body thus equipped and replace the
holding flange.
• Place the counter electrode on the projector equipped
with the deflector and nozzle nut and connect it.
(see § 6.4.2 page
35).
28
DRT7133
D - 2023/01
Member of Exel group
Advertisement
Table of Contents
