Procedure C1: Rear Body - Sames inocoat Inogun A Instruction Manual

6.4.3. Procedure C1: Rear body

Removal:
• Gently fire to separate the rear body from the gun.
• Disengage the connector using a small screwdriver of
3 to press the tab.
• Loosen the ground screw.
• Check the general condition, wires, terminal and
connector, replace the rear body if necessary.
Installation:
• Replace the rear body, taking care not to pinch the
wires.
Connect the ground wire, press the wire against the
protective cover assembly..
• Connect the blue connector.
• Twist the blue connector 1/4 turn to position it
longitudinally in the protective cover.
The wiring makes a "S".
• Then push the rear body against the gun.
• Using an ohmeter, test the continuity between the HV
contact and the protective cover.
36
DRT7133
D - 2023/01
Member of Exel group