Table of Contents
Advertisement
8. Maintenance
Note: This paragraph applies only to the maintenance of the Inocart cart.
For specific maintenance of the gun
Disconnect the power supply to the control module before connecting the gun. Before
disconnecting the gun, switch off, cut off the power supply to the control module (otherwise
a malfunction may occur).
8.1. Maintenance summary table
The soiling and wear of the different elements of the Inocart carriage caused by the passage of the powder depends
on the nature of the powder and the operating conditions.
Therefore, the periodicity of maintenance indicated in the procedures below is only indicative. The user will have to
create his own maintenance range as he uses the Sames equipment.
Procedure
A
Cleaning of the cart
B
Powder pump / plunger tube cleaning
C1
Replacement of filter
C2
Replacement of vibrator
C
C3
Replacement of elastic pads of the vibrating table
C4
Fast Clean replacement
C5
Replacement of the equipped porous washer
Member of Exel group
(see
DRT7132) and the Inobox control module
Detail
Cleaning
Replacement
23
(see
DRT7145).
Duration
Frequency
2 mn
8 Hours
8 Hours or at each
2 mn
color change
30 mn
-
1 Hour
-
5 mn
-
5 mn
-
15 mn
-
B - 2023/03
DRT7159
Advertisement
Table of Contents
