Table of Contents
Advertisement
6. Maintenance
Preventive maintenance is an essential part of production and ensures the reliability of the installation. As a reminder,
the performance of equipment can only be guaranteed if a minimum of control and cleaning operations are performed
on this equipment.
Soiling and wear of the Inogun M gun caused by the passage of powder depend on the
operating and application conditions and the production rates.
Switch off the power supply to the control module before connecting the spray gun. Before
disconnecting the spray gun, switch off, disconnect the power supply to the Inocontroller or
Inobox (otherwise, a malfunction may occur).
Never throw or intentionally drop the gun. Dropping the gun could damage the high-voltage
unit. After a fall, it is recommended to check the operation of the gun out of the area before re-
use and its condition.
6.1. Summary table of maintenance operations
The maintenance intervals indicated in the procedures below are only indicative. The user will have to create his own
maintenance schedule as he use Sames equipment.
Procedure
A1
Cleaning of spray gun exterior
A
A2
Cleaning of electrode support and deflector
Spray gun maintenance
B
B1
Replacement of fixing hook
B2
Replacement of trigger
Barrel maintenance
C1
Assembly / Disassembly barrel / handle
C
C2
Replacement of HVU
C3
Replacement of air connector o-rings
Handle maintenance
D1
Powder duct
D
D2
Replacement of low voltage cable
D3
Replacement of control box
Detail
Cleaning
Replacement
23
DRT7132
D - 2022 /09
Duration
Frequency
2 min
8 Hours
2 min
8 Hours
2 min
-
5 min
-
5 min
-
5 min
-
5 min
-
2 min
-
5 min
-
5 min
-
Member of Exel group
Advertisement
Table of Contents
