Table of Contents
Advertisement
6. Installation
The Inocart VT or H carts are delivered assembled.
6.1. Vibrating table version
• Step 1: Place the support arm in its housing.
• Step 2: Place the plunger tube (A) equipped with the
CS 130 pump in the support arm and connect the 2
hoses to the powder pump blue to blue, red to red.
Connect the fluidizing hose to the tube.
• Step 3: Connect the 5 m earthing cable to an
electrically earthed part of the application booth.
• Step 4: Connect the Inobox's power supply plug.
• Step 5: Connect the powder supply hose from the
gun to the CS 130 pump and connect the electrode
blowing hose on the Inobox module side and on the
gun side.
The Inocart cart is ready to start the powder application.
Member of Exel group
18
A
DRT7159
B - 2023/03
Advertisement
Table of Contents
