Turn Signal Light; Stoplight/Taillight; Ignition Switch - KYMCO Zing 125 Service Manual

18
. LIGHTS/INSTRUMENTS/SWITCHES/HORN

TURN SIGNAL LIGHT

Remove the two turn signal light shell
screws and the bulb.
Check the bulb for damage and replace with
a new one if necessary.
The installation sequence is the reverse of
removal.
STOP LIGHT/TAILLIGHT
Remove the two taillight shell screws and the
shell.
Remove the bulb and check the bulb for
damage. Replace with a new one if
necessary.
Bulb Specification: 12V.18/5W

IGNITION SWITCH

Disconnect the ignition switch wire coupler.
Remove the two bolts attaching the ignition
switch.
Remove the ignition switch.
INSPECTION
Check for continuity between the wires
indicated below.
Color
Black
Position
OFF
○ ○ ○ ○
ON
Black/
Red Green
White
○ ○ ○ ○ ○ ○ ○ ○
○ ○ ○ ○
Bulb
Reflector
Bulb
Wire Coupler
Light Shell
Screws
Screws
Bolts
18-2