KYMCO Zing 125 Service Manual page 38

3
. LUBRICATION SYSTEM
ENGINE OIL/OIL FILTER
OIL LEVEL
＊ ＊ ＊ ＊
• Place the motorcycle upright on level
ground for engine oil level check.
• Run the engine for 2～3 minutes and
check the oil level after the engine is
stopped for 2～3 minutes.
Check the oil level through the watch
window. If the level is near the lower limit,
fill to the upper limit with the specified
engine oil.
OIL CHANGE
＊ ＊ ＊ ＊
The engine oil will drain more easily
while the engine is warm.
Remove the drain bolt to drain the engine oil
thoroughly.
Check the drain bolt washer for damage or
deformation and replace with a new one if
necessary.
Remove the oil filter screen cap and then
remove the oil filter screen and spring.
Clean the oil filter screen with compressed
air.
Check the filter screen cap O-ring for
damage or deformation and replace if
necessary.
Install the oil filter screen, spring and filter
screen cap.
Torque: 1.5kg-m
＊ ＊ ＊ ＊
Do not install the oil filter screen upside
down.
Oil Capacity: At disassembly : 1.1 liter
At change
Check for oil leaks and then start the engine
and let it idle for few minutes.
Stop the engine and recheck the oil level.
: 1.0 liter
Upper Limit
Lower Limit
Drain Bolt
Oil Filter Screen Cap
3-2