Service Information; Troubleshooting; Turn Signal Light; Stop Light/Tail Light - KYMCO Active 50 Service Manual

18
. LIGHTS/INSTRUMENTS/SWITCHES/HORN/

FUEL UNIT

SERVICE INFORMATION

GENERAL INSTRUCTIONS
• All plastic plugs have locking tabs that must be released before disconnecting.
• An electric tester must be used for checking the continuity between two points. The electric
tester also contains a voltmeter which can be used to measure voltage.
• Different bulbs have different specifications. When replacing, use a new bulb of the same
specifications to avoid damage of the electrical equipment.
• The continuity check of switches can be made without removing the switches from the
motorcycle.
SPECIFICATIONS
Headlight
Stoplight/Taillight

Turn signal light

Turn signal indicator light
Instrument light
High beam indicator light
Fuse

TROUBLESHOOTING

Light does not come on when ignition
switch is "ON"
• Burned bulb
• Faulty ignition or light switch
• Fuse burned out
• Dead battery or loose battery wire
Light comes on but dims
• Weak battery
• Wire or switch resistance too high
• Aged bulb or faulty lighting circuit
18-1
12V 35/35W
12V 21/5W
12V 10Wx4
12V 3.4W x2
12V 1.7Wx2
12V 1.7W
10A
Headlight beam does not change when
dimmer switch is operated
• Faulty or burned bulb
• Faulty dimmer switch
• Loose wire connection
ACTIVE 50