KYMCO Zing 125 Service Manual page 39

3
. LUBRICATION SYSTEM
OIL PUMP/OIL FILTER ROTOR
REMOVAL
1. Remove the kick lever.
2. Disconnect the clutch cable.
3. Remove the right crankcase cover bolts
and right crankcase cover.
4. Check the cover gasket, oil seal and O-ring
for oil leaks or damage. Replace with new
ones if necessary.
＊ ＊ ＊ ＊
When installing, make sure to use a new
right crankcase cover gasket.
Remove the three screws attaching the oil
filter rotor cover to remove the cover.
Remove the oil filter rotor lock nut with a
square socket and then remove the washer
and oil filter rotor.
＊ ＊ ＊ ＊
During installation, install the washer
with the mark "OUTSIDE" facing up.
Remove the oil pump gear cover.
Remove the 6mm nut on top of the oil pump
driven gear.
Remove the oil pump driven gear and chain.
Remove the two oil pump mounting bolts.
Remove the oil pump body.
3-3
Right Crankcase Cover
Oil Pump
Oil Pump Body
Screws
Oil Filter Rotor
Oil Pump Driven Gear
Drive Gear
Bolts