KYMCO Zing 125 Service Manual page 81

8. STARTER MOTOR/GENERATOR/LEFT CRANK-
CASE COVER/STARTER CLUTCH/CAMSHAFT
Bolt
Reduction Pinion
STARTER CLUTCH REMOVAL
Remove the bolt attaching the starter gear set
plate.
Remove the starter gear.
Set Plate Starter Gear
INSPECTION
Measure the starter gear shaft I.D.
Service Limit: 22.062mm replace if over
Starter Gear
Measure the starter gear shaft O.D.
Service Limit: 42.534mm replace if below
Micrometer Calipers
Micrometer Calipers
Roller
Measure the starter clutch roller O.D.
Service Limit: 9.95mm
8-3