Table of Contents
Advertisement
Before You Begin
Create a New Module
Configure the ASCII Module
Topic
Before You Begin
Create a New Module
Edit the Module Configuration Categories
View the Module Tags
This chapter describes how to configure your POINT I/O ASCII module in a
Studio 5000 Logix Designer application project. You can use the default
module configuration or edit the module configuration.
IMPORTANT Consider the following:
• You must use the Studio 5000 Logix Designer application, version 17 or
later, to configure POINT I/O modules. Version 31 or later is slightly different
from previous software versions. For example, in some cases, instead of
tabs across the top of the Module Properties dialog box, the application
uses categories on the left side of the dialog box.
• This chapter does not explain each user-configurable module feature that
you can edit on different screens in your Studio 5000 Logix Designer
application project.
You must complete the following tasks before you can configure the module:
1. Create a Studio 5000 Logix Designer application project.
2. Add a POINT I/O EtherNet/IP adapter to the project.
For more information on how to add a POINT I/O EtherNet/IP adapter to
a Studio 5000 Logix Designer application project, see the POINT I/O and
ArmorPOINT® I/O Dual Port EtherNet/IP Adapters User Manual,
publication 1734-UM017, or the POINT I/O EtherNet/IP Adapters User
Manual, publication 1734-UM018.
After you create a Studio 5000 Logix Designer application project and add a
POINT I/O EtherNet/IP adapter to the project, complete these steps to add
modules to the project.
This example shows how to add a 1734-485ASC module when the Studio 5000 Logix
Designer application project is offline.
Rockwell Automation Publication 1734-UM009C-EN-P - August 2022
2
Chapter
Page
15
15
17
21
15
Advertisement
Table of Contents
