Rockwell Automation Allen-Bradley 1734-232ASC Original Instructions Manual page 16

Chapter 2 Configure the ASCII Module
16
1. Right-click on the POINT I/O Chassis node and choose New Module.
2. Select the module and click Create.
You can use filters to minimize the number of modules displayed as
shown.
Clear the Close on Create checkbox if you intend to add more than one module.
The New Module dialog box appears. You can click OK to use the default
configuration as shown or edit the module configuration.
To add additional I/O modules in the same rack, complete one of the following:
• If you cleared the Close on Create checkbox when you created the first
I/O module, repeat step 2.
• If you did not clear the Close on Create checkbox when you created the
first I/O module, repeat steps 1...2.
Rockwell Automation Publication 1734-UM009C-EN-P - August 2022