Johnson Controls METASYS User Manual page 69

Change-of-State
(COS)
CLEAR
CLOCK
COMMAND
CONTINUE
Control System
(CS) object
current analog
value
D600 Controller
data point
deadband
DELETE
differential
For an object, the act of transforming from one condition to another in
realtime (e.g., a binary input object changing from Normal to Alarm).
An NT command option that removes the object from the HOLD
summary.
An NT screen option that accesses the system clock to set the time, date,
or holidays.
An NT command option that allows you to manually change the state of
an object.
An NT screen option that proceeds to the next screen.
Represents a control system as a software object. The CS object
attributes are selected analog, binary, and multistate points in the
controller. Used for AHU, UNT, VAV, and LCP controllers only.
Current reading from a hardware sensor. Analog values can be displayed
in positive or negative values, with one digit to the right of the decimal
point.
An intelligent access controller that can manage up to sixteen card
readers within a facility.
Software that corresponds to and characterizes a specific value that is not
associated with an actual field device (e.g., the result of an equation).
See normalband.
An NT screen option that removes scheduled programs from the system.
The value that prevents excessive alarm and warning reports that result
from fluctuations above and below the limits. When an analog input
object crosses over a limit, causing the object to go into either alarm or
Network Terminal User's Manual 69