Johnson Controls METASYS User Manual page 46

46 Network Terminal User's Manual
Changing Schedules
This section explains how to add or modify weekly, holiday, and
-
one time schedules, and how to schedule times to adjust or command an
object, or change a setpoint.
Note: Fire Zone and Access objects cannot be scheduled for
communications commands at the NT. They can only be
Enabled or Disabled manually. (See the Override Control
section of this manual.)
The SCHEDULE command is available when you select one of the
following software object types: ACM, AI, BO, BD, AOS, AD, LCG,
PIDL, CS, or L2.
The route you take to access the Scheduling feature depends on the
period you are dealing with (Alternate, Regular, or Holiday) and the
particular object you want to schedule. For scheduling, objects divide
into three sets. The scheduling options available depend on which of the
following objects you select:
ACM, AI, BO, BD, AOS, PIDL, CS, or L2
AD
Lighting Control Group
To perform any type of scheduling, you begin by selecting the system,
the object (or lighting group), and the SCHEDULE command. Then
follow the instructions for the particular object you are scheduling.