Commanding
Access Controller
and Card Reader
Objects
38 Network Terminal User's Manual
You can use the Network Terminal to control both Access Controller
hardware objects and Card Reader software objects.
The Access Controller (AC) object is the hardware object that defines the
interface between the D600 Access Controller and the NCM. With the
NT, you can :
Reset
--
silence all sounding alarms.
Access --
command all doors to an open state in an emergency.
Normal --
command all doors to their normal states according to
their commanding feature.
Select an available option,
then press ENTER.
NC_4_HDW
bldg #1, 3rd floor east
*
ACCESCON
IAC600 Access Controller
HELP
RESET
Figure 16: Command Screen for the AC Hardware Object
The Card Reader (CR) object is the software object that represents a
Smart Terminal Interface/Card Reader combination in an Access Control
system. With the NT, you can:
Open
--
unlock a door in the secure mode, allowing temporary
access without the use of an access card. The door
remains in the Open state until the defined access time
has expired. The door will go into alarm if it is held
open longer than the defined shunt time.
ONLINE
DISABLE
*
ACCESS
NORMAL
HOLD
LOG OFF
HOME
REFRESH
PREVIOUS
FIG14
Need help?
Do you have a question about the METASYS and is the answer not in the manual?