Table of Contents
Advertisement
Passport 1000 PG
Mortise Lock
7
Installation Instructions - Change Hand of Lock Body, continued
b
Reverse Lock Hand
Red surface of locking piece must face the outside/locked side of door. To rotate locking piece (Figure 7B):
1. Position lock body with red surface of locking piece visible.
2. Insert blade type screwdriver into locking piece slot to rotate locking piece toward back of lock body.
3. Rotate the locking piece 180° until RED surface is on opposite side.
Note: Red indicates locked side (outside). Wire harness MUST exit through the non-cylinder side (inside) of the
lock body (Figure 7C).
c
Reverse Latch Hand
Beveled surface of latchbolt must face strike (Figure 7C1).
The deadlatch is self adjusting.
To change the hand of the latchbolt:
1. Insert the blade of a slotted screwdriver (>1/4") into
the spade shape slot behind latch.
2. Rotate the screwdriver 90° to push latchbolt out
until back of bolt clears lock case front.
3. Rotate latchbolt 180° until the latchbolt drops back
into the lock body.
Note: Latch cannot be unscrewed.
1-800-727-5477 • www.sargentlock.com
Copyright © 2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
Red Locking Piece
Indicates Locked Side
Locking Slide
Red on Locked Side
Figure 7B
Right Hand
Lock Shown
Push In
Spade
Shaped
Slot
9
Latchbolt
Deadlatch
Figure 7C
A7807D 12/22
Advertisement
Table of Contents
