Table of Contents
Advertisement
Delayed Egress 57-80 Series
Exit Device
Installation Instructions
4
Cylinder Installation
1. Prepare door according to template(s) and instructions supplied with exit device.
2. Verify cylinder (size varies; consult factory) is installed in rail insert with collar prior to installing exit device on
door.
Remove and Replace Cylinder
1. Ensure power is disconnected.
2. Loosen set screw by turning counter-clockwise using
5/64" allen wrench.
3. Extract and slide cylinder through spring and collar.
Note:
When replacing cylinder, slide cylinder through spring then collar,
taking care to orient cylinder as shown. Hold cylinder into proper
position and slowly tighten set screw until cylinder is securely held
by set screw. Do NOT overtighten set screw.
Cylinder Orientation
See illustration on circuit board for correct orientation of
cylinder when installing.
Note:
The proper position of cam allows for removal of key.
1-800-727-5477 • www.sargentlock.com
Copyright © 2005, 2007, 2023, SARGENT Manufacturing Company. All rights reserved. Reproduction in whole or
in part without the express written permission of SARGENT Manufacturing Company is prohibited. Patent pending
and/or patent www.assaabloydss.com/patents.
Top View of Insert
Side View of Insert
Cylinder with Key
Set Screw
Top View with cylinder removed
Cylinder Cam
Top of Cylinder
Bottom of Cylinder
8
Spring
Collar
Illustration (on circuit board)
A7743F 1/23
Advertisement
Table of Contents
