Table of Contents
Advertisement
Passport 1000 PG
Mortise Lock
20
LockSet Programming, continued
a
Start the PERSONA LockLink™ Software
1. Tap
2. If visible, select PERSONA LockLink™ to launch
the program; otherwise, tap Start and Programs
to launch the Programs list and then select the
PERSONA LockLink™ icon (right).
3. Log into the LockLink™ by tapping the arrow and
selecting your username from the drop down list:
4. Type in your password. You can use the onscreen keyboard entry method to
enter information.
5. To access the full screen keyboard (shown at right) tap on the ellipsis
(three dots) next to the password fi eld.
Once you have entered your password, you will begin on the Upload screen.
This is the proper place to be for programming locks.
Note: Be sure to perform an Operational Check (see Section 9) for each lock.
b
Upload Full Program
After locks are installed, they must have program fi les copied into them before they can receive and interpret
data. In many ways, the program fi les act as the locks' operating system by interpreting the lock data to control
each lock's behavior.
1. Highlight (by tapping) the name of the lock
that you wish to program.
If the list of locks is longer than the display,
locate the lock using the scroll bar at the
right of the display or use the
at the top of the display.
2. Tap the
initialize the lock; the message "Alert! Make
sure the Contact Card is Inserted or has
power."
3. Tap "ok."
1-800-727-5477 • www.sargentlock.com
Copyright © 2012, 2022, SARGENT Manufacturing Company. All rights reserved.
Reproduction in whole or in part without the express written permission of SARGENT Manufacturing
Company is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
on the Pocket PC Screen.
button to completely
button
18
A7807D 12/22
Advertisement
Table of Contents
