Assembling The Appliance; Charging The Battery; Filling The Clean Water Tank - Tesla AquaStar AQ500 Manual

ASSEMBLING THE APPLIANCE

CHARGING THE BATTERY

FILLING THE CLEAN WATER TANK

Press the Clean water tank release button and remove the tank. Open the lid and fill the tank with warm
tap water (max. 60°C). If necessary, add a non-foaming detergent suitable for cleaning hard floors and
close the lid tightly. Insert the Clean water tank back into the body of the appliance until you hear a
click.
WARNING! Always make sure that all filters have been inserted in the dirty water tank before using the
appliance.
Insert the end of the handle into the hole in the body
of the appliance.
Secure the handle by screwing in the handle
fastening screw.

Fully charge the battery before first use.

Ambient temperature must be between 4°C and 40°C.

Before charging the battery, make sure the water tanks are
empty and the appliance is dry.

The appliance cannot be used for cleaning while charging.

If the battery is almost empty, the battery status indicator
will start to flash red. Connect the charging cable to the
appliance and plug it into a wall socket. If the charging
indicator flashes blue, the battery is charging.

When the battery is fully charged, the indicator will be
continuously lit blue for 2 minutes and then go out.

Charging time is approx. 3 - 4 hours.

Charge the appliance regularly to achieve optimal
performance.

Store the appliance in a dry place.

Use only the supplied charger. Make sure that the voltage
indicated on the type plate of the power pack corresponds
to the mains voltage.