Graco HFR Setup page 69

a. Not Ready (Dark or OFF) - This will occur when
not in a dispense mode (disable or night
modes), the user is on a setup screen when
idle, an alarm is active, the system is in low
pressure recirculation mode or not moving (full
recirculation type systems only), the system is
performing a manual or semi-automatic recir-
culation operation (Auto Circulate Between Dis-
penses is OFF), or when the stall to pressure
logic is OFF (Fusion/P2 dispense valve type
systems only).
b. Ready (LED is flashing at a rate of 4 hertz) -
This will occur when all conditions outlined in
the previous state are NOT true, the system is
idle (or in high pressure recirculation mode if
using a full recirculation system), and when the
system is NOT dispensing.
c. Dispensing (LED is ON) - This will occur when
the system is actively dispensing material out
of the valve, or when recirculating material
through a manual or semi-automatic recircula-
tion kit.
• Light Tower Options - If using the light tower
option for the HFR, the user must select the correct
light tower option used with their system. The Stan-
dard 3 Light and Custom Clear Lens options are
currently available using the drop-down selection.
• Blue Token Reader – This feature is represented
by the blue token graphic shown next to the bottom
left softkey graphic (
this function, first enter the screen by pressing the
top left soft key (
screen, the bottom left soft key will be enabled
( ), which allows the user to trigger a token read-
ing.
3A2797ZAA
). To enable
). Once entered into the
Appendix B - ADM Setup Screens Overview
Insert the programmed blue token into the token
reader slot on the bottom right hand side of the
ADM module, then press the
new token read. After a token read is complete, the
screen will provide the token data file part number
and description.
If the data on the token is not recognizable or the
token is blank, the screen will display a message
reading "Token Data NOT Recognized." If another
token needs read, insert the next token and drigger
a read by pressing the
key to trigger a
key.
69