Eaton Cutler-Hammer FP 5000 Instruction Leaflet page 183

IL17569B
Page 12-18 Effective Date: 12/05
The next screen will prompt the user to Enter-Flash-Load-Mode, see
Figure 12-8.
Figure 12-8. Flash Programmer
When the user clicks on the "Enter Flash Load Mode" pushbutton
the Erase pushbutton and the Program pushbutton become active.
Clicking the "Enter Flash Load Mode" pushbutton switches the relay
from normal mode to flash load mode, see figure 12-9.
Figure 12-9. Flash Programmer
The recommended procedure is to first erase the memory by
pushing the "Erase" button. A message will be displayed stating that
"Erasing in progress", see Figure 12-10.
The FP-5000 will display "Flash Loader Mode – Erase in progress".
This process takes approximately 20 seconds to several minutes to
complete depending on the size of the program. When completed, a
message will appear on the screen "Erased properly! Click Program
to download the application code", see Figure 12-11.
Page 12-18
FP-5000
For more information visit: www.eatonelectrical.com
Figure 12-10. Flash Programmer
Figure 12-11. Flash Programmer
The FP-5000 will display Flash Loader Mode "App code erased."
If a user chooses not to erase the FP-5000 and proceed with the
program downloading, the FP-5000 will not allow the new program to
be entered unless the memory has been erased. Screen messages
will appear instructing the user how to proceed. If the user selects
"Exit Flash Loader" the program is aborted. If the user selects
"Program" the unit will begin to program if its memory has been
erased. If the memory has not been erased a message will appear
instructing the user to erase before programming.
Effective Date: 12/05