Table of Contents
Advertisement
Installation
Install Liners
The following guidelines apply for all liners (with the
exception of the 739RGL Refl ective Glass Liners—see
the installation manual supplied with that liner kit for
details).
1. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Remove the fuel bed support (2 screws).
3. Remove the burner cover (2 screws).
4. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side. The
panel should be parallel to the edge of the burner
plate. Slide the panel forward. Rotate the anchor
back down to hold the panel.
18
5. Place the rear panel against the back of the fi rebox
resting it on the ledge at bottom. Two tabs are hold-
ing it. Slide it behind the left side panel to hold it.
6. Rotate the anchor up and out of the way and slide
the right hand side panel against the fi rebox side.
The panel should be parallel to the edge of the
burner plate. Rotate the anchor back down to hold
the panel.
7. Tighten the side brick anchors on each side of the
fi rebox.
8. Reinstall the burner cover being careful not to
scratch the brick while inserting it into the fi rebox.
Secure it (2 screws).
Liner Panels
Advertisement
Table of Contents
