Install Liner Panels - Valor H4 Series Installation & Owner's Manual

Install Liner Panels

All liner panels can be installed as indicated below
except the 618RGL—Refl ective Glass Liners—see
instructions supplied with the liners.
Unpack the liners carefully to avoid scratching or
damaging them.
1. Place the rear panel against the back of the fi rebox
on the ledge of the rear log support. Make sure the
bevel part is at the top.
2. Hold the left hand side panel at an angle and insert its
bottom edge inside the fi rebox. Rotate the panel to a
vertical position ensuring that the top edge is behind
the fl ange of the fi rebox. Pull the panel as forward as
possible against the left edge of the fi rebox.
3. Hold the right hand side panel at an angle and insert
its bottom edge inside the fi rebox. Rotate the panel to
a vertical position ensuring that the top edge is behind
the fl ange of the fi rebox. Pull the panel as forward as
possible against the right edge of the fi rebox.
Installation
4. Insert the top panel over the left side panel while
holding the top panel forward up the slope. Rotate
the right side of the top panel upwards and place it
over the top of the right panel.
Slide the top panel down the slope of the fi rebox as
far as possible to close the gap with the rear panel
and to maximize the gap above the front edge of the
top panel.
QUALIFIED
INSTALLER
35