Table of Contents
Advertisement
Adjust Fuel Bed Support (if necessary)
The appliance is supplied with the fuel bed support
already installed. All fuel beds can be used with this
support.
The fuel bed support is factory-installed in a specifi c
position and include a front fl ange which can be
adjusted if necessary. To adjust the position of the
fl ange, release its 3 retaining screws and move the
fl ange as required. Tighten the screws.
Install Liner Panels
The following guidelines apply for all liners except
the 739RGL Refl ective Glass Liners which require
some preparation prior to installation—see instructions
packed with liners.
1. Inside the fi rebox, on the top of each side, release
the screw of the side brick anchors (one per side)
just enough to allow them to rotate.
2. Place the rear panel against the back of the fi rebox,
on the ledge at bottom.
Installation
Moving the fl ange forward will allow more impigement/
glow/fl ame height; moving the fl ange backward will do
the opposite.
Note: The rock support included with the Rock Set
739RSK it is no longer necessary; recycle or discard it.
3. Rotate the anchor up and out of the way and slide
the left hand side panel against the fi rebox side.
The panel should be parallel to the edge of the
burner plate. Rotate the anchor back down to hold
the panel.
Rotate anchor up and
insert panel
QUALIFIED
INSTALLER
Side panels
should be
parallel to
edge of
burner plate
Edge of
burner plate
Position of panel in
relation to burner plate
29
Advertisement
Table of Contents
