Table of Contents
Advertisement
6
VARIOUS SETTINGS
This chapter describes the setting procedures of the multiple input module.
This chapter uses GX Works2 for explanations.
6.1
Parameter Setting
Set the parameter of this module with the network parameter written to the CPU module of the master station. For the setting
procedure of the master station, refer to the following manual.
User's manual for the master/local module used
• Before parameter settings, "Set network configuration setting in CC IE Field configuration window" needs to
be selected on the "MELSECNET/CC IE/Ethernet Module Configuration" window.
• When points less than the ones of the multiple input module are set for the remote I/O signal and remote
register, no error occurs. The cyclic transmission is performed for the data of the points set from the start.
Precautions
■Precautions before parameter settings
For the precautions before parameter settings, refer to the following.
GX Works3 Operating Manual
GX Works2 Version 1 Operating Manual (Common)
■Precautions for parameter settings
• When using the multiple input module, always enable the block data assurance per station. When it is disabled, correct
operation of the multiple input module cannot be guaranteed. For details on the block data assurance per station, refer to
the user's manual for the master/local module used.
• Do not set the parameter using the CCPASET instruction in the master station. Correct operation of the multiple input
module cannot be guaranteed because the module operates with the block data assurance per station disabled when the
CCPASET instruction is executed. (The CCPASET instruction is intended to configure parameters for a master/local
module. For details on the CCPASET instruction, refer to the user's manual for the master/local module used.)
6 VARIOUS SETTINGS
50
6.1 Parameter Setting
Advertisement
Table of Contents
Troubleshooting
