Chapter 5 Installation And Wiring; Switch Setting; Station Number Setting - Mitsubishi Electric NZ2GF2S-60MD4 User Manual

5
INSTALLATION AND WIRING
This chapter describes the installation and wiring of the multiple input module.
5.1

Switch Setting

Station number setting

Set the station number with the rotary switch on the front of the module. The setting value of the station number becomes
valid when the module is powered on. Thus, set the station number when the module is powered off.
• The hundreds and tens places of the station number are set with x10.
• The ones place of the station number is set with x1.
Ex.
To set the station to 115, set the switch as shown below.
Setting range
Set the station number from 1 to 120. Setting the value other than 1 to 120 causes a communication system error and the D
LINK LED flashes.
• Changing the station number setting switch while the module is powered on causes a minor error and
flashes the ERR. LED. Returning the station number setting switches to the previous setting eliminates the
error after five seconds and turns off the ERR. LED.
• Do not set a station number duplicated with other station numbers. If the station number is duplicated, a
communication system error occurs and the D LINK LED does not turn on.
5 INSTALLATION AND WIRING
30
5.1 Switch Setting