Mitsubishi Electric NZ2GF2S-60MD4 User Manual page 44

■Installation procedure
Move the lever to the locking lever position and push the terminal block. If the terminal block is fully pushed in, the hook of the
lever hangs on the module and fits the terminal block.
The terminal block can be inserted with the lever locations other than the lock lever position.
After insertion, confirm that the lever is in the lock lever position.
Connecting and disconnecting the cable
■Connecting the cable
Wire covering shall be as follows.
• Strip length: 10mm
Insert wire in which the tip thereof has been processed into a wire insertion opening (2) and push it to the back.
If the wire cannot be inserted by this method, insert the wire to the back while pressing the release button (1) using a flathead
screwdriver with a tip width of 2.0 to 2.5mm.
(1)
Pull the wire or bar solderless terminal lightly to confirm that it is securely clamped.
■Disconnecting the cable
Pull the wire while pressing the release button using a flathead screwdriver with a tip width of 2.0 to 2.5mm.
Precautions
• Use a bar solderless terminal for the wiring to the push-in type spring clamp terminal block. If a stripped wire is inserted into
a wire insertion opening (1), the wire cannot be securely clamped.
• For how long the wire should be stripped, follow the specifications of the bar solderless terminal used. To attach a bar
solderless terminal to a wire, use a crimping tool.
• Before inserting a bar solderless terminal into a wire insertion opening (1), check the shape of the opening and the shape of
the terminal. Insert the terminal paying attention to the orientation. If a bar solderless terminal larger than the wire insertion
opening (1) is inserted, the terminal block may be damaged.
(1)
2.4mm
1.5mm
5 INSTALLATION AND WIRING
42
5.4 Wiring
(2)