List Of Remote Buffer Memory Areas - Mitsubishi Electric NZ2GF2S-60MD4 User Manual

2.6

List of Remote Buffer Memory Areas

This section lists the remote buffer memory areas of the multiple input module.
Range of remote buffer memory addresses
The following table lists the ranges of remote buffer memory addresses occupied by multiple input modules.
For details on the remote buffer memory, refer to the following.
Page 117 Details of Remote Buffer Memory Areas
: Available, : Not available
Address
Decimal Hexadecimal
0 to 255 0000H to 00FFH
256 to 511 0100H to 01FFH
512 to 1279 0200H to 04FFH
1280 to 1535 0500H to 05FFH
1536 to 1791 0600H to 06FFH
1792 to 2559 0700H to 09FFH
2560 to 4095 0A00H to 0FFFH
4096 to 4351 1000H to 10FFH
4352 to 4607 1100H to 11FFH
4608 to 5375 1200H to 14FFH
*1 For the REMFR and REMTO instructions, refer to the following.
 User's manual for the master/local module used
*2 For the access method, refer to the following.
Parameter area (Page 50 Parameter Setting)
Error history area (Page 92 Checking for the Error Codes and the Alarm Codes)
• Do not access the system area using the REMFR or REMTO instruction. Doing so may lead the module to
malfunction.
• Do not use the dedicated instruction of the REMFR and REMTO instructions to the areas later than the
above areas. If these instructions are used, the remote buffer memory access error (error code: 0160H) is
stored in Latest warning code (RWr1), Warning flag (RX7) turns on, and the ERR. LED flashes.
Area Target
Parameter area Station-based
parameter data
Module-based
parameter data
System area
Monitoring area Station-based monitor
data
Module-based monitor
data
System area
Error history area Station-based error
history data
Module control data Station-based control
area data
Module-based control
data
System area
Access method
CC IE Field REMFR instruction,
configuration of the REMTO
engineering tool instruction
 
*2
 
 
 
 
*2
 
 
 
2 SPECIFICATIONS
2.6 List of Remote Buffer Memory Areas
2
*1
21