Table of Contents
Advertisement
Thermo Scientific
Cleaning and Disinfection
If the unit has been in service, disconnect the power cord from both the unit and
the power source. Allow the unit to cool before proceeding with any
maintenance.
Before using any cleaning or decontamination method except those
recommended by the manufacturer, users should check with the manufacturer
that the proposed method would not damage equipment.
It is the responsibility of the user to immediately clean up after all accidental
spills of hazardous materials. Be certain to follow local EHS policies with regards
to personal protective equipment, cleaning, and disposal.
Cleaning
The chamber interior may be cleaned with a general-use laboratory disinfectant, such as
quaternary ammonium, or alcohol.
The cabinet exterior may be cleaned with soap and water or any nonabrasive commercial
glass cleaner.
Alcohol, even a 70% solution, is volatile and flammable. Use it only in a well
ventilated area that is free from open flame. If any component is cleaned with
alcohol, do not expose the component to open flame or other possible hazards.
Allow the alcohol to fully dry before turning power on.
Do not use strong alkaline or caustic agents. Stainless steel is corrosion
resistant, not corrosion proof. Do not use solutions of sodium hypochlorite
(bleach) as they may cause pitting and rust.
Cleaning and Disinfection |
Chapter 8
Model 3962 | 8-1
Advertisement
Table of Contents
