Calibration - Thermo Scientific 3962 Operating Manual

| Handling and Control
Chapter 7
Figure 7-3 Set Mode

Calibration

After the unit has stabilized, the air temperature can be calibrated to reference
instruments. To access Calibration mode, press the Mode key until the Cal indicator lights.
Press the right and/or left arrow until the proper parameter appears in the message
center. See Figure 7-4 on page 7-6 at the end of this section for more detail.
Calibration frequency is dependent on use, ambient conditions and accuracy required. A
good laboratory practice would require at least an annual calibration check. On new
installations, all parameters should be checked after the stabilization period.
|
7-4 Model 3962 Thermo Scientific