Maximum Cable Length; Standard Bracket; Rotary Bracket - Hatteland JH 10T06 MMD User Manual

General Installation Recommendations

Maximum Cable Length

The RGB/DVI cable should generally be kept as short as possible to provide a high quality output
on the display. The maximum cable length will depend on the signal resolution and frequency, but
also on the quality of the signal output from the computer. We recommend using 60Hz vertical
frequency for our displays.
Cables up to 10 meters generally provides good picture quality even with a 1600x1200 (UXGA)
60Hz signal. In most cases (especially with lower resolutions) even longer cables will provide a
satisfactory result. This should however be tested in advance before making the decision on how
far the unit can be placed from the signal source.

Standard Bracket

When mounting the bracket on the MMD/STD products, the length of the bolts should not exceed
12mm. Using any longer bolts will do serious damage to components inside the product, and will
void warranty!
Mount bolts on both sides of the bracket/display.
You make any adjustments before securing the bolts.
Adjust the tilting angle and secure the bolts.
Note: MMC bracket may vary in placement and design, but length of bolts should not
exceed 12mm.

Rotary Bracket

This can only be mounted if your product is equipped with a Standard Bracket.
Use the provided bolts to secure it. You may choose your own bolts to secure it to a table or
desktop, recommended size are: M10 and minimum 30mm in length. The rotary bracket can be
rotated 180°
Installation 19
INB100005-1 (Rev 19)
IND100078-1