Communication Settings #2 (After Jan 2005) - Hatteland JH 10T06 MMD User Manual

Serial Communication (SCOM) Interface

Communication settings #2 (after Jan 2005)

The communication options are set by switches, placed at the backside of the display. These
switches are protected behind a hatch mounted with four screws. Unscrew those, and remove the
hatch. The communication settings are placed like seen on the illustration below. For adjustments,
a thin object is required for reaching the switches.
NOTE: By factory default the comport is set to RS232 mode, unless customer specified.
Communication mode
[ Note: JHSCOM placement for products released and introduced AFTER Jan 2005]
Communication Interface
IND100084-1
Straight/Reverse
Rx/Tx for RS422, COM1
7
Protection Hatch
Duplex
Address
INB100005-1 (Rev 19)