Hatteland JH 10T06 MMD User Manual page 32

Physical Connections - MMD/STD Models
DVI-D IN:
Connect the DVI cable to the DVI-D 24P Connector (female) on the rear side of the TFT display.
If possible, screw the DVI cable to the DVI-D connector and make sure you don't bend any of the pins
inside the DVI cable connector. To reduce tension of the DVI cable, secure it to the base mounted cable tie
clamp. Connect the other end of the cable to the DVI-D output of your computer, and fasten it there also.
POWER INPUT: (AC Version)
The internal AC power module supports both 115VAC/60Hz and 230VAC/50Hz power input. You may
secure the cable further by mounting it to the base mounted cable tie clamp.
POWER INPUT: (DC Version)
Secure the cables (check polarity!) to the screw terminal, you may secure the cable further by mounting it
to the base mounted cable tie clamp. The internal DC power module supports voltage from 12 to 24 VDC
depending on the product model. Please check specifications for your exact product/type number
elsewhere in this manual!
SERIAL INTERFACE: (optional)
The two serial remote control connectors are used for displays with the JHSCOM-A1/C1. It features a
RS232/RS422/RS485 interface for controlling parameters, including brightness, for the display. To set the
switches, please see the Appendix chapter "Serial Communication (SCOM) Interface" in this manual.
For in-depth information, see www.hatteland.com - "Support/Accessories/JHSCOM/Technical Manual".
Note:
If you have optional accessories beyond these standard connectors described here, please visit our
website at www.hatteland.com for separate documentation/specifications regarding accessories (when
made available).
IND100133-1
2
INB100005-1 (Rev 19)