Table of Contents
Advertisement
2.3 Motherboard Installation
All motherboards have standard mounting holes to fit different types of chassis. Make sure
that the locations of all the mounting holes for both the motherboard and the chassis match.
Although a chassis may have both plastic and metal mounting fasteners, metal ones are
highly recommended because they ground the motherboard to the chassis. Make sure that
the metal standoffs click in or are screwed in tightly.
Tools Needed
Phillips
Phillips Screws
Screwdriver (1)
(11)
Location of Mounting Holes
Note 1: To avoid damaging the motherboard and its components, please do not use
a force greater than 8 lbf-in on each mounting screw during motherboard installation.
Note 2: Some components are very close to the mounting holes. Please take precau-
tionary measures to avoid damaging these components when installing the mother-
board to the chassis.
Standoffs (11)
Only if Needed
JS1
JS2
35
Chapter 2: Installation
JVGA1
VGA
USB0/1
IPMI_LAN
(3.0)
BMC
BIOS
BMC FW
BATTERY
AIOM:CPU1 PCI-E 4.0 X16
BT1
PCH
JBT1
CMOS CLEAR
X12DPFR-AN6
REV:1.01
CPU1
BAR CODE
CPU2
5
JPWR1
JPWR2
Advertisement
Table of Contents
