Supermicro X12DPFR-AN6 User Manual page 13

Power Management
•
ACPI power management
•
Power-on mode for AC power recovery
•
Intel® Intelligent Power Node Manager 3.0 (available when the Supermicro Power Manager [SPM] is installed and a
special power supply is used. See the note on page 20.)
•
Management Engine (ME)
System Health Monitoring
•
Onboard voltage monitoring for +1.8V, +3.3V, +5V, +12V, +3.3V standby, +5V standby, HT, memory, PCH temperature,
system temperature, and memory temperature
•
CPU 5+1-phase switching voltage regulator
•
CPU thermal trip support
•
Status monitor for on/off control
•
CPU Thermal Design Power (TDP) support of 165W (See Note 1 below.)
Fan Control
•
Three 4-pin fan headers
•
Fan status monitoring via BMC
•
Low-noise fan speed control
System Management
•
Trusted Platform Module (TPM) support
•
PECI (Platform Environment Control Interface) 2.0 support
•
Power supply monitoring
•
SuperDoctor® 5, Watch Dog, Non-maskable interrupt (NMI), RoHS
Firmware Integrity/System Security
•
TPM (Trusted Platform Module) support
•
RoT (Root of Trust) support to protect firmware security by detecting critical data corruption, and restoring platform integrity
LED Indicators
•
CPU/Overheating
•
Power/Suspend-state indicator
•
Fan failure
•
UID/remote UID
•
HDD activity
•
LAN activity
Dimensions
•
8.5" (W) x 19.66" (L) ATX (215.90 mm x 499.36 mm)
Note 1: The CPU maximum thermal design power (TDP) is subject to chassis and
heatsink cooling restrictions. For proper thermal management, please check the chas-
sis and heatsink specifications.
Note 2: For BMC configuration instructions, please refer to the Embedded BMC Con-
figuration User's Guide available at http://www.supermicro.com/support/manuals/.
13
Chapter 1: Introduction