Supermicro X12DPFR-AN6 User Manual page 88

Super X12DPFR-AN6 User's Manual
SATA RAID Option ROM/UEFI Driver (Available when "Configure SATA as" is set to
RAID)
Select EFI to load the EFI driver for system boot. Select Legacy to load a legacy driver for
system boot. The options are Disable, EFI, and Legacy.
SATA Port 0 - SATA Port 7
Hot Plug
Select Enable to support Hot-plugging for the device installed on a selected SATA port
which will allow the user to replace the device installed in the slot without shutting down
the system. The options are Enable and Disable.
Spin Up Device
Select Enable for Staggered Spin Up support which will allow the SATA devices specified
by the user to spin up one at a time at boot to prevent all hard drive disks from spinning
up at the same time, causing a power surge. The options are Enable and Disable.
SATA Device Type
Use this feature to specify if the device installed on the SATA port specified by the user
should be connected to a Solid State drive or a Hard Disk Drive. The options are Hard
Disk Drive and Solid State Drive.
PCH sSATA Configuration

When you select this submenu and press <Enter>, the following screen will display.
88