Powtran PI9100 Series Manual page 235

Appendix I
100B
100C
100D
100E
100F
1010
1011
1012
1013
1014
1015
1016
1017
1018
1019
101A
101B
101C
101D
101E
101F
1020
Note:
There is two ways to modify the settings frequencies through communication
mode:
The first: Set F0.03 (main frequency source setting) as 0/1 (keyboard set
frequency), and then modify the settings frequency by modifying F0.01 (keyboard
set frequency). Communication mapping address of F0.01 is 0xF001 (Only need to
change the RAM communication mapping address to 0x0001).
The second :Set F0.03 (main frequency source setting) as 9 (Remote
communication set), and then modify the settings frequency by modifying
(Communication settings). , mailing address of this parameter is 0x1000. the
communication set value is the percentage of the relative value, 10000 corresponds
to 100.00%, -10000 corresponds to -100.00%. For frequency dimension data, it is
the percentage of the maximum frequency (F0.19); for torque dimension data, the
percentage is F5.08 (torque upper limit digital setting).
Control command is input to the inverter: (write only)
AI2 voltage
Reserve
Count value input
Length value input
Load speed
PID setting
PID feedback
PLC step
High-speed pulse input frequency, unit: 0.01kHz
Feedback speed, unit:0.1Hz
Remaining run time
AI1 voltage before correction
AI2 voltage before correction
Reserve
Linear speed
Current power-on time
Current run time
High-speed pulse input frequency, unit: 1Hz
Communication set value
Actual feedback speed
Master frequency display
Auxiliary frequency display
230