Powtran PI9100 Series Manual page 202

DI1
DI2
DI3
DI4
DI5
DI6
DI7
Digital
input
DI8
DI5
DA1-
GND
Analog
output
DA2-
GND
SPA-COM
SPB-COM
Digital
output
SPB-COM
T/A1-
T/C1
Relay
output
T/B1-
T/C1
J12
Auxiliar
y
interface
J13
2.Input impedance: 20kΩ with voltage input,
510Ω with current input.
Digital input 1 1.Opto-coupler isolation, compatible with
bipolar input
Digital input 2
2.Input impedance: 4.7kΩ
Digital input 3
3.Voltage range with level input: 9V to 30V
Digital input 4
4 . Below 11KW: (DI1 to DI6)drive manner is
Digital input 5
controlled by J5, when external power supply
Digital input 6
is used to drive, please unplug J5 jumpers ,
Digital input 7
5 . Above 11KW: (DI1 to DI4)drive manner is
Digital input 8
Except the function of DI1 to DI4,DI6 to
High-speed
DI8,DI5 can also be used as high-speed pulse
pulse input
input channels.Maximum input frequency:
terminals
100kHz
The selected J2 jumper on control panel
Analog output determines voltage or current output. Output
1 voltage range: 0V to 10V , output current
range: 0mA to 20mA
The selected J1 jumper on control panel
Analog output determines voltage or current output. Output
2 voltage range: 0V to 10V , output current
range: 0mA to 20mA
Digital output Opto-coupler isolation, bipolar open collector
1
output
Output voltage range: 0V to 24V , output
Digital output
current range: 0mA to 50mA
2
Subject to function code(F2.00)"SPB terminal
High-speed output mode selection"
pulse output As a high-speed pulse output, the highest
frequency up to 100kHz;
Normally
open terminals
Contactor drive capacity: normally closed
contact 5A/AC 250V，normally open contact
Normally
closed 3 A/AC 250V，1A/ DC 30V, COSø = 0.4.
terminals
485 card
26-pin terminal
interface
PG card
12-pin terminal
interface
197
Chapter 8 Installation and Spare Circuit
controlled by J6, (DI5 to DI8)drive
manner is controlled by J5, when external
power supply is used to drive, please
unplug J5 jumpers ,